Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (for TMMK Made)

REAR BUMPER (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER PLATE LH


    B381244E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws.
    Text in Illustration 
    *a
    Hook
    V100155
    Protective Tape

  1. Disengage the hook and remove the rear bumper plate LH.



2. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER ASSEMBLY


    B400915
  1. Apply protective tape around the rear bumper assembly as shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape



    B400916
  1. Remove the 2 screws.



    B400917
  1. Remove the 7 screws.
    Text in Illustration 
    V100135
    Screw
    V100136
    Clip

  1. Using a clip remover, remove the 4 clips.



    B381249
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B381250E02
  1. Disengage the claw (A).
    Text in Illustration 
    *a
    Screwdriver
    V100155
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws (B) as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



    B400921
  1. Disengage the 6 claws as shown in the illustration.

  1. Remove the rear bumper assembly.