Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR

WASHER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


  1. for TMC, TMMR Made:



      E226631
    1. Remove the 3 screws and front wheel opening extension pad RH.



  1. for TMMK Made:



      E301060
    1. Remove the 3 screws and front wheel opening extension pad RH.



3. REMOVE FRONT FENDER LINER RH


  1. for TMC, TMMR Made:



      E231344
    1. Remove the clip.



    2. E226453E01
    3. Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clip.
      Text in Illustration 
      *a
      90°



    4. E226455E01
    5. Remove the 5 screws.
      Text in Illustration 
      *1
      Grommet

    6. Remove the 4 clips, 2 grommets and front fender liner RH.

      HINT:
      The grommets need to be replaced with new ones because they will break when they are removed.



  1. for TMMK Made:



      E300693
    1. Remove the clip.



    2. E300694E02
    3. Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clip.
      Text in Illustration 
      *a
      90°



    4. E300695E02
    5. Remove the 5 screws and bolt.
      Text in Illustration 
      *1
      Grommet

    6. Remove the 4 clips, 3 grommets and front fender liner RH.

      HINT:
      The grommets need to be replaced with new ones because they will break when they are removed.



4. DRAIN WASHER FLUID


    E228031
  1. Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



5. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    E228033
  1. Disconnect the connector.

  1. Remove the windshield washer motor and pump assembly as shown in the illustration.