CYLINDER BLOCK > REPLACEMENT |
| 1. REPLACE STRAIGHT PIN |
Using a plastic hammer, tap in new straight pins to the cylinder block.

| *a | Front Cylinder Block | *b | Rear Cylinder Block |
| *c | Upper Cylinder Block | *d | Lower Cylinder Block |
| *e | Cylinder Block RH Side | - | - |
| Item | Protrusion |
| Pin A | 23 mm (0.906 in.) |
| Pin B | 6 mm (0.236 in.) |
| Pin C | 11 mm (0.433 in.) |
| Pin D | 9 mm (0.354 in.) |
| 2. REPLACE STUD BOLT |
Using an E8 and E10 "TORX" socket wrench, install the stud bolts.

| *a | Front Cylinder Block | *b | Cylinder Block LH Side |