Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

  5. Check for DTCs (Click here).

    NOTICE:
    The navigation receiver assembly*1 or radio and display receiver assembly*2 outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
    System
    Proceed to
    Navigation System (for Navigation Receiver Type)*1
    Click here
    Audio and Visual System (for Radio and Display Type)*2
    Click here
    1. *1: for Navigation System (for Navigation Receiver Type)
    2. *2: for Audio and Visual System (for Radio and Display Type)


CLEAR DTC
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

  5. Clear the DTCs.