Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for TMC, TMMR Made)

FRONT BUMPER (for TMC, TMMR Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E301634
  1. Extend the headlight washer actuator sub-assembly.

  1. Disengage the claw to remove the headlight washer nozzle sub-assembly.



2. REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E301626
  1. Disconnect the headlight cleaner hose.



    E301627
  1. Remove the headlight cleaner clamp as shown in the illustration.



    E301629
  1. Pull the headlight cleaner actuator clamp as shown in the illustration.



  1. While pushing the tab indicated by the arrow (A), disengage the claw and guide to remove the headlight washer actuator sub-assembly as shown in the illustration.


    E301631E01



4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



5. REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)


    B382637
  1. Disengage the 8 clamps to remove the headlight cleaner hose.



6. REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

HINT:
Use the same procedure for all No. 1 ultrasonic sensors.



    E305606
  1. Disconnect the connector.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



    E305607
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



7. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

HINT:
Use the same procedure for all No. 1 ultrasonic sensor retainers.



    E305608
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the front bumper assembly.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



8. REMOVE FOG LIGHT ASSEMBLY LH
  1. Disconnect the connector.



    E301896
  1. Remove the screw.

  1. Disengage the 2 guides to remove the fog light assembly.



9. REMOVE FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



10. REMOVE NO. 4 ENGINE ROOM WIRE (w/o TOYOTA Parking Assist-sensor System)


    B382638
  1. Disengage the clamp to remove the No. 4 engine room wire.

    HINT:
    Use the same procedure for the RH side and LH side.



11. REMOVE NO. 4 ENGINE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)


    B382639
  1. Disengage the clamp to remove the No. 4 engine room wire.

    HINT:
    Use the same procedure for the RH side and LH side.



12. REMOVE FRONT FENDER LINER RETAINER


    B382640
  1. Disengage the claw to remove the front fender liner retainer.

    HINT:
    Use the same procedure for the RH side and LH side.



13. REMOVE NO. 2 RADIATOR GRILLE BRACKET


    B382641
  1. Remove the 2 screws.

  1. Disengage the guide to remove the No. 2 radiator grille bracket.



14. REMOVE RADIATOR GRILLE SUB-ASSEMBLY


    B382642
  1. Remove the 2 clips.

  1. Disengage the 8 claws and remove the radiator grille sub-assembly.



15. REMOVE UPPER RADIATOR GRILLE MOULDING LH


    B382644
  1. Remove the screw.

  1. Disengage the 3 claws and remove the upper radiator grille moulding LH.



16. REMOVE UPPER RADIATOR GRILLE MOULDING RH

HINT:
Use the same procedure as for the LH side.



17. REMOVE RADIATOR GRILLE EMBLEM ASSEMBLY


    B382648
  1. Remove the 2 screws.

  1. Disengage the 4 claws and 2 guides to remove the radiator grille emblem assembly with radiator grille emblem base.



    B382649
  1. Disengage the 3 claws and guide to remove the radiator grille emblem assembly from the radiator grille emblem base.



18. REMOVE RADIATOR GRILLE BRACKET


    B385534
  1. Remove the clip.

  1. Disengage the guide to remove the radiator grille bracket.



19. REMOVE FRONT BUMPER HOLE COVER LH


    B382652
  1. Disengage the 6 claws to remove the front bumper hole cover LH.



20. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedure as for the LH side.



21. REMOVE LOWER FRONT BUMPER COVER


    B382650E01
  1. Disengage the 4 claws.
    Text in Illustration 
    *a
    Hook

  1. Disengage the hook and remove the lower front bumper cover.



22. REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY


  1. Remove the 4 screws.


    B382653



  1. Disengage the 24 claws and remove the lower radiator grille sub-assembly from the front bumper cover.


    B382655



23. REMOVE FRONT BUMPER ENERGY ABSORBER


    B385518
  1. Disengage the 2 guides to remove the front bumper energy absorber.



24. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B281859
  1. Disengage the 5 clamps.

  1. Remove the 6 bolts and front bumper reinforcement sub-assembly.



25. REMOVE FRONT BUMPER SIDE RETAINER LH


    B281875
  1. Remove the bolt and screw.

  1. Disengage the 2 claws and remove the front bumper side retainer LH.



26. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.