Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (for TMMK Made)

REAR BUMPER (for TMMK Made) > REASSEMBLY

for Preparation Click here



1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B381257
  1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque:
    61 N*m{ 622 kgf*cm , 45 ft.*lbf }



2. INSTALL REAR BUMPER ENERGY ABSORBER


    B381256
  1. Engage the 2 guides to install the rear bumper energy absorber.



3. INSTALL REAR BUMPER SIDE SEAL LH


    B381253
  1. Engage the guide and claw.



    B381252
  1. Install the 2 screws.

  1. Install the rear bumper side seal LH with a new grommet.



4. INSTALL REAR BUMPER SIDE SEAL RH


    B381255
  1. Engage the guide and claw.



    B381254
  1. Install the 2 screws.

  1. Install the rear bumper side seal RH with a new grommet.



5. INSTALL REAR BUMPER SIDE RETAINER LH


    B381259
  1. Engage the 3 claws.

  1. Engage the 3 clips to install the rear bumper side retainer LH as shown in the illustration.



6. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



7. INSTALL REAR BUMPER LOWER COVER


  1. Engage the 2 guides and 10 claws.


    B400919



    B400918
  1. Install the 2 clips.

  1. Install the rear bumper lower cover with the 2 outside moulding retainers.