Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH

BLIND SPOT MONITOR MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BLIND SPOT MONITOR MAIN SWITCH ASSEMBLY (WARNING CANCELING SWITCH ASSEMBLY)
  1. Engage the 2 claws to install the blind spot monitor main switch assembly (warning canceling switch assembly).



2. INSTALL NO. 1 SWITCH HOLE BASE


    E227702
  1. Connect the connector.

  1. Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  1. Remove the protective tape from the panel.