Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH

BLIND SPOT MONITOR MAIN SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 SWITCH HOLE BASE


    E227701E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, disengage the 4 claws and 2 guides as shown in the illustration.

  1. Disconnect the connector and remove the No. 1 switch hole base.



2. REMOVE BLIND SPOT MONITOR MAIN SWITCH ASSEMBLY (WARNING CANCELING SWITCH ASSEMBLY)


    E302646
  1. Disengage the 2 claws to remove the blind spot monitor main switch assembly (warning canceling switch assembly).