Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Center Floor)

ELECTRICAL KEY OSCILLATOR (for Center Floor) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMC, TMMR Made)
  1. Install the No. 2 indoor electrical key antenna assembly with the 2 bolts.

    NOTICE:
    Be careful when installing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

  1. Connect the connector.



2. INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMMK Made)
  1. Engage the clamp to install the No. 2 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when installing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

  1. Connect the connector.



3. INSTALL REAR SEAT CUSHION LOCK HOOK (for TMC, TMMR Made)
  1. for Fold Down Seat Type:
  2. for Reclining Seat Type:


4. INSTALL REAR SEAT CUSHION LOCK HOOK (for TMMK Made)


    B393388
  1. Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



5. INSTALL REAR SEAT CUSHION ASSEMBLY (for TMC, TMMR Made)
  1. for Fold Down Seat Type:
  2. for Reclining Seat Type:


6. INSTALL REAR SEAT CUSHION ASSEMBLY (for TMMK Made)
  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.



    B280250
  1. Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.

  1. Confirm that the rear seat cushion assembly is securely installed.

    NOTICE:
    When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.