Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH (for TMMK Made)

LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL LUGGAGE COMPARTMENT DOOR LOWER OUTSIDE GARNISH PROTECTOR

HINT:
Use the same procedure for the RH side and LH side.

  1. Clean the luggage compartment door outside garnish.

    1. Remove any remaining double-sided tape from the luggage compartment door outside garnish.

    2. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from a new luggage compartment door lower outside garnish protector.

    HINT:
    After removing the release paper, keep the exposed adhesive free from foreign matter.

  1. Install the luggage compartment door lower outside garnish protector.



2. INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH PROTECTOR
  1. Clean the luggage compartment door outside garnish.

    1. Remove any remaining double-sided tape from the luggage compartment door outside garnish.

    2. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from a new luggage compartment door outside garnish protector.

    HINT:
    After removing the release paper, keep the exposed adhesive free from foreign matter.



  1. Install the luggage compartment door outside garnish protector as shown in the illustration.


    B381013E01


    Standard Measurement:

    Area
    Measurement
    -
    -
    A
    1.5 mm (0.0591 in.)
    -
    -



3. INSTALL LUGGAGE COMPARTMENT DOOR UPPER OUTSIDE GARNISH LH
  1. Engage the 3 claws to install the luggage compartment door upper outside garnish LH.



4. INSTALL LUGGAGE COMPARTMENT DOOR UPPER OUTSIDE GARNISH RH

HINT:
Use the same procedure for the RH side and LH side.



5. INSTALL REAR TELEVISION CAMERA ASSEMBLY
  1. Engage the 2 claws to install the rear television camera assembly.



6. INSTALL LUGGAGE ELECTRICAL KEY SWITCH
  1. Install the luggage electrical key switch.



7. INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
  1. Install 6 new gaskets to the luggage compartment door outside garnish.

  1. Install 4 new clips to the luggage compartment door outside garnish.

  1. Engage the 4 clips.

  1. Install the luggage compartment door outside garnish sub-assembly with the 6 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the 2 connectors.



8. INSTALL REAR LIGHT ASSEMBLY LH


    E300989E01
  1. Install the rear light assembly with the 4 nuts.

    Torque:
    Nut (A):
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }
    Nut (B):
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }

  1. Connect the connector.



9. INSTALL REAR LIGHT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.



10. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    B380679
  1. Install the luggage compartment door cover with the 13 clips.