Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH (for TMC, TMMR Made)

LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH (for TMC, TMMR Made) > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT DOOR COVER


    B281699
  1. Remove the 13 clips and luggage compartment door cover.



2. REMOVE REAR LIGHT ASSEMBLY LH


    E227533
  1. Disconnect the connector.

  1. Disengage the clamp.

  1. Remove the 4 nuts and rear light assembly.



3. REMOVE REAR LIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
  1. w/ Smart Entry and Start System:

    1. Disconnect the connector.

  1. w/ Rear View Monitor System:

    1. Disconnect the connector.



    B382691
  1. Remove the 5 nuts.



    B382692E01
  1. Apply protective tape around the luggage compartment door outside garnish sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Back Door Outside Garnish Clip
    V100155
    Protective Tape

  1. Disengage the 3 clips and remove the luggage compartment door outside garnish sub-assembly.

  1. Remove the clip (back door outside garnish clip) and 2 clips from the luggage compartment door outside garnish sub-assembly.

  1. Remove the 5 gaskets from the luggage compartment door outside garnish sub-assembly.



5. REMOVE LUGGAGE ELECTRICAL KEY SWITCH COVER (w/o Smart Entry and Start System)


    B382696
  1. Remove the luggage electrical key switch cover.



6. REMOVE LUGGAGE DOOR OPENING SWITCH ASSEMBLY (w/ Smart Entry and Start System)


    B281713
  1. Remove the luggage door opening switch assembly.



7. REMOVE LUGGAGE COMPARTMENT DOOR EMBLEM


    B282054E01
  1. Put protective tape around the luggage compartment door emblem.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the luggage compartment door emblem.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)


    E300913
  1. Disengage the 2 claws to remove the rear television camera assembly.



9. REMOVE NO. 2 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH


    B382695
  1. Remove the 2 screws.

  1. Disengage the 4 claws and remove the No. 2 luggage compartment door outside garnish.



10. REMOVE UPPER BACK DOOR GARNISH MOULDING PROTECTOR


    B382697
  1. Remove the upper back door garnish moulding protector.



11. REMOVE BACK DOOR GARNISH MOULDING PROTECTOR LH


    B385531
  1. Remove the back door outside garnish protector LH.



12. REMOVE BACK DOOR GARNISH MOULDING PROTECTOR RH

HINT:
Use the same procedure as for the LH side.