Home › Engine / Hybrid System ยท 6AR-FSE › EMISSION CONTROL › CANISTER

CANISTER > INSPECTION

for Preparation Click here



1. INSPECT CANISTER (CHARCOAL CANISTER ASSEMBLY)
  1. Visually check the canister (charcoal canister assembly).

    1. Visually check the canister (charcoal canister assembly) for cracks or damage.
      If cracks or damage are found, replace the canister (charcoal canister assembly).



  1. Check canister (charcoal canister assembly) air flow.



      A255922E03
    1. Using a vacuum pump, check that air flows through the canister (charcoal canister assembly) according to the table below.
      Text in Illustration 
      *a
      Port (A)
      *b
      Port (B)
      *c
      Port (C)

      Standard:
      Condition
      Specified Condition
      Block port (B) and (C) and apply 2 kPa (15 mmHg, 0.591 in. Hg) of vacuum into port (A)
      There are no leaks
      Block port (B) and apply 2 kPa (15 mmHg, 0.591 in. Hg) of vacuum into port (A)
      Air is sucked into port (C)
      Block port (C) and blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into port (A)
      Air comes out of port (B)
      Blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into port (A)
      Air comes out of port (B) and (C)

      If the result is not as specified, replace the canister (charcoal canister assembly).



2. CLEAN FILTER IN CANISTER (CHARCOAL CANISTER ASSEMBLY)


    A256493E03
  1. Clean the filter by blowing 5 kPa (0.1 kgf/cm2, 0.7 psi) of compressed air into the port (A) while holding the port (B) closed.
    Text in Illustration 
    *a
    Port (A)
    *b
    Port (B)
    *c
    Air

    NOTICE:
    1. Make sure to clean the filter using only air, do not use gasoline or any other means.
    2. Do not disassemble the canister (charcoal canister assembly).