Home › Vehicle Interior › LIGHTING (INT) › FRONT DOOR COURTESY SWITCH (for TMMK Made)

FRONT DOOR COURTESY SWITCH (for TMMK Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
  1. Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the screw.

    Torque:
    6.3 N*m{ 64 kgf*cm , 56 in.*lbf }

    HINT:
    There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

  1. Connect the connector.



2. INSTALL CENTER PILLAR LOWER GARNISH
  1. Engage the 2 claws and 3 clips to install the center pillar lower garnish LH.



3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
for LH Side:
for RH Side:


4. INSTALL REAR DOOR SCUFF PLATE
  1. Engage the 6 claws to install the rear door scuff plate LH.

    HINT:
    Engage the claws from the rear side of the scuff plate.



5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
for LH Side:
for RH Side:


6. INSTALL FRONT DOOR SCUFF PLATE
  1. Engage the 10 claws to install the front door scuff plate LH.