Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT (for TMC, TMMR Made)

VANITY LIGHT (for TMC, TMMR Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


2. REMOVE VANITY LIGHT ASSEMBLY


    E227552E01
  1. Tilt the tab to disengage the 2 claws <A> and separate the bulb holder from the vanity light as shown in the illustration.
    Text in Illustration 
    *1
    Tab
    *2
    Claw <A>
    *3
    Bulb Holder
    *4
    Claw <B>

  1. Disengage the claw <B> and remove the vanity light assembly.