Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT (for TMMK Made)

VANITY LIGHT (for TMMK Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


2. REMOVE VANITY LIGHT ASSEMBLY


    E226705E01
  1. Tilt the tab to disengage the 2 claws <A> and separate the bulb holder from the vanity light as shown in the illustration.
    Text in Illustration 
    *1
    Tab
    *2
    Claw <A>
    *3
    Bulb Holder
    *4
    Claw <B>

  1. Disengage the claw <B> and remove the vanity light assembly.