Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY (for TMC, TMMR Made)

SIDE TURN SIGNAL LIGHT ASSEMBLY (for TMC, TMMR Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER MIRROR (w/o Memory)


    B280618E04
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.



    B280619E03
  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.
    Text in Illustration 
    *a
    Moulding Remover



    B280621
  1. Disengage the 2 guides as shown in the illustration.



    B280623
  1. Disconnect the 2 connectors and remove the outer mirror.



2. REMOVE OUTER MIRROR (w/ Memory)


    B384676E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.

  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.



    B384677E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the lower part of the mirror surface and tilt it.

  1. Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.



    B384681E01
  1. Disconnect the mirror heater connector.
    *a
    Mirror Heater Connector
    *b
    Blind Spot Monitor Indicator Connector

  1. Disengage the 2 claws.

  1. Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

    NOTICE:
    1. Do not bend the tabs excessively to prevent them from being damaged.
    2. If the tabs are damaged, replace the outer mirror with a new one.



3. REMOVE OUTER MIRROR COVER (w/o Memory)


    B280624
  1. Remove the 3 screws.



    B280625
  1. Disengage the clamp.

  1. Disconnect the 2 connectors and remove the mirror actuator.



    B280627
  1. Disengage the 7 claws and remove the outer mirror cover.



4. REMOVE OUTER MIRROR COVER (w/ Memory)


    B386127
  1. Disengage the 5 claws.



    B386129E01
  1. Disengage the 2 claws to remove the outer mirror cover as shown in the illustration.

    HINT:
    When removing the outer mirror cover, pull the outer mirror cover horizontally along the lower part of the outer rear view mirror assembly.



5. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    E225012
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the side turn signal light assembly.