Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
  1. Install the rear combination light assembly with the 4 nuts.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }

  1. Engage the clamp.

  1. Connect each connector.



2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER
  1. Install the 3 clips.

  1. Engage the fastener and install the luggage compartment inner trim cover LH.



3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B283877E01
  1. Engage the pin to install the No. 1 luggage compartment trim hook.
    Text in Illustration 
    *1
    Pin



4. INSTALL REAR FLOOR FINISH PLATE


    B294807
  1. Engage the 4 clips and install the rear floor finish plate.

  1. Install the 5 clips.



5. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)
  1. Install the baggage holder net.



6. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
  1. Install the luggage compartment floor mat.



7. INSTALL REAR BUMPER ASSEMBLY
(Click here)