Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY (for TMMK Made)

LICENSE PLATE LIGHT ASSEMBLY (for TMMK Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE LUGGAGE COMPARTMENT DOOR COVER


    B380679
  1. Remove the 13 clips and luggage compartment door cover.



2. REMOVE UPPER BACK DOOR OUTSIDE GARNISH MOULDING


    E300986E01
  1. Apply protective tape around the upper back door outside garnish moulding.
    Text in Illustration 
    *a
    Protective Tape

  1. Using a screwdriver wrapped with protective tape, disengage the 3 claws to remove the upper back door outside garnish moulding.



3. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E226675
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the license plate light assembly.



4. REMOVE LICENSE PLATE LIGHT BULB


    E255008E06
  1. Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it in the direction shown in the illustration and disengage the 2 claws to remove the license plate light lens.
    Text in Illustration 
    *a
    Protective Tape
    *b
    Insert into the hole



    E255009
  1. Remove the license plate light bulb.