Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR SENSOR (for TMC, TMMR Made)

SOLAR SENSOR (for TMC, TMMR Made) > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B281758
  1. Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.



    B281757
  1. Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.



2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY


    B281761
  1. Disengage the 6 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 1 speaker opening cover assembly.



3. REMOVE SOLAR SENSOR (AUTOMATIC LIGHT CONTROL SENSOR)


    E227546
  1. Disengage the 2 claws and remove the solar sensor (automatic light control sensor).