Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR (for TMMK Made)

AUTOMATIC LIGHT CONTROL SENSOR (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY


    B377624
  1. Using a moulding remover, disengage the 11 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 1 speaker opening cover assembly.



2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    E300723
  1. Disengage the 2 claws and remove the automatic light control sensor.