WIPER ECU > REMOVAL |
| 1. REMOVE FRONT PANEL GARNISH |
![]() |
Disengage the 3 clips and 8 guides to remove the front panel garnish RH.
| 2. REMOVE FRONT DOOR SCUFF PLATE |
| 3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY |
| 4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Disconnect the front door opening trim weatherstrip RH.
| 5. REMOVE INSTRUMENT SIDE PANEL |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.
| 6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Disengage the 4 claws.
Disengage the 2 guides.
Disconnect the connector to remove the No. 2 instrument panel under cover sub-assembly.
| 7. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Remove the bolt <B> and screw <D>.
Open the lower instrument panel door.
![]() |
Remove the 3 screws <D>.
![]() |
Disengage the 2 clips, 4 guides and remove the lower instrument panel sub-assembly as shown in the illustration.
| 8. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY |
![]() |
Disconnect the connector.
Remove the nut and windshield wiper relay assembly.