Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY (for TMMK Made)

REAR LIGHT ASSEMBLY (for TMMK Made) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE REAR COMBINATION LIGHT PROTECTOR


    E300991
  1. Remove the rear combination light protector.



2. REMOVE REAR LIGHT GASKET


    E315277
  1. Disengage the 2 claws and 2 guides, and remove the rear light gasket.

    NOTICE:
    1. Be sure to remove any remaining old gasket from the vehicle body.
    2. Do not reuse the removed gasket. Be sure to install a new rear light gasket to prevent water ingress.



3. REMOVE BACK-UP LIGHT BULB


    E300992
  1. Turn the back-up light socket plug with the back-up light bulb as shown in the illustration to remove them as a unit.

  1. Remove the back-up light bulb from the back-up light socket plug.