Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for TMMK Made)

DTC    B1690/15    Door Side Airbag Sensor RH Malfunction

for Preparation Click here


DESCRIPTION

The side collision sensor RH circuit (to determine deployment of the front seat airbag assembly RH, rear seat airbag assembly RH, curtain shield airbag assembly RH and front seat outer belt assembly RH) is composed of the airbag sensor assembly, side airbag sensor assembly RH, side No. 2 airbag sensor assembly RH and door side airbag sensor RH.
The door side airbag sensor RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed.
DTC B1690/15 is stored when a malfunction is detected in the door side airbag sensor RH.

DTC No.
DTC Detection Condition
Trouble Area
B1690/15
  1. Door side airbag sensor RH malfunction
  2. Airbag sensor assembly malfunction
  1. Door side airbag sensor RH
  2. Airbag sensor assembly

WIRING DIAGRAM

Refer to DTCs B1622/81, B1623/81, B1632/81, B1633/81, B1642/81, B1692/81 and B1693/81 .

INSPECTION PROCEDURE

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).

1.CHECK DOOR SIDE AIRBAG SENSOR RH


    C238395E01
  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Interchange the door side airbag sensor RH with LH and connect the connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the engine switch off.

  1. Turn the engine switch on (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1690/15 is output.
    A
    DTC B1695/16 is output.
    B
    DTCs B1690/15 and B1695/16 are not output.
    C

    HINT:
    Codes other than DTCs B1690/15 and B1695/16 may be output at this time, but they are not related to this check.

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the door side airbag sensor RH and LH to their original positions and connect the connectors.
    Text in Illustration 
    *1
    Door Side Airbag Sensor LH
    *2
    Side No. 2 Airbag Sensor Assembly RH



B
REPLACE DOOR SIDE AIRBAG SENSOR RH (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE AIRBAG SENSOR ASSEMBLY (Click here)