Home › Engine / Hybrid System ยท 6AR-FSE › LUBRICATION › OIL PRESSURE SENSOR

OIL PRESSURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    A304094E01
  1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.
    Text in Illustration 
    *a
    Adhesive 1344
    *b
    Oil Inlet Port

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    NOTICE:
    1. Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.
    2. Install the oil pressure sender gauge assembly within 3 minutes of applying adhesive.

  1. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

  1. Connect the oil pressure sender gauge assembly connector.



2. INSPECT FOR OIL LEAK
  1. Start the engine. Make sure that there are no engine oil leaks from the area that was worked on.



3. INSTALL NO. 2 ENGINE MOUNTING STAY RH
  1. Install the No. 2 engine mounting stay RH with the 2 bolts.

    Torque:
    38 N*m{ 387 kgf*cm , 28 ft.*lbf }



4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Engage the 3 grommets to install the No. 1 engine cover sub-assembly.