Home › Engine / Hybrid System ยท 6AR-FSE › LUBRICATION › OIL PRESSURE SENSOR

OIL PRESSURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE NO. 2 ENGINE MOUNTING STAY RH


    A338525
  1. Remove the 2 bolts and No. 2 engine mounting stay RH.



3. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY
  1. Disconnect the oil pressure sender gauge assembly connector.



    A338567
  1. Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.