CYLINDER HEAD > DISASSEMBLY |
| 1. REMOVE EXHAUST VALVE |

| *A | Type A (Compression Spring Shape: Straight) | *B | Type B (Compression Spring Shape: Tapered) |
| *1 | No. 1 Valve Rocker Arm Sub-assembly | *2 | Valve Spring Retainer |
| *3 | Compression Spring | *4 | Valve Lash Adjuster Assembly |
Type A:
![]() |
Using SST and wooden blocks, compress the compression spring and remove the 16 valve spring retainer locks.
Type B:
![]() |
Using SST and wooden blocks, compress the compression spring and remove the 16 valve spring retainer locks.
Remove the 8 valve spring retainers, 8 compression springs and 8 exhaust valves.
| 2. REMOVE INTAKE VALVE |

| *A | Type A (Compression Spring Shape: Straight) | *B | Type B (Compression Spring Shape: Tapered) |
| *1 | No. 1 Valve Rocker Arm Sub-assembly | *2 | Valve Spring Retainer |
| *3 | Compression Spring | *4 | Valve Lash Adjuster Assembly |
Type A:
![]() |
Using SST and wooden blocks, compress the compression spring and remove the 16 valve spring retainer locks.
Type B:
![]() |
Using SST and wooden blocks, compress the compression spring and remove the 16 valve spring retainer locks.
Remove the 8 valve spring retainers, 8 compression springs and 8 intake valves.
| 3. REMOVE VALVE STEM OIL SEAL |
![]() |
Using needle-nose pliers, remove the oil seals.
| 4. REMOVE VALVE SPRING SEAT |
![]() |
Using compressed air and a Magnet Hand, remove the valve spring seat by blowing air onto it.
| 5. REMOVE NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 10 mm hexagon wrench, remove the 3 screw plugs and 3 gaskets.
| 6. REMOVE NO. 2 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm hexagon wrench, remove the screw plug and gasket.
| 7. REMOVE STUD BOLT |