LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE OIL LEVEL |
Warm up and stop the engine, and then wait 5 minutes.
Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.
If the level is low, check for leakage and add oil up to the full level mark.
| 2. INSPECT ENGINE OIL QUALITY |
Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter.
| 3. INSPECT OIL PRESSURE |
Remove the oil pressure switch assembly (Click here).
![]() |
Install an oil pressure gauge with the adapter.
| *1 | Oil Pressure Gauge |
Warm up the engine.
Measure the oil pressure.
| Condition | Specified Condition |
| Idle | 30 kPa (0.3 kgf/cm2, 4.4 psi) or more |
| 4000 rpm | 260 kPa (2.7 kgf/cm2, 38 psi) or more |
Remove the oil pressure gauge with the adapter.
Install the oil pressure switch assembly (Click here).