Home › Vehicle Interior › INTERIOR PANELS / TRIM › FRONT CONSOLE BOX (for TMMK Made)

FRONT CONSOLE BOX (for TMMK Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY


    B287379
  1. Disengage the 4 claws and 4 clips to remove the console rear end panel sub-assembly.



2. REMOVE REAR CONSOLE ARMREST ASSEMBLY


    B277993
  1. Using a screwdriver, remove the 2 E-rings.

    NOTICE:
    Be careful not to allow the E-rings to pop out when removing them.



    B277994
  1. Using a screwdriver, pull out the 2 box door hinge shafts.

    HINT:
    1. Tape the screwdriver tip before use.
    2. The illustration is for the LH side.
    3. Use the same procedure for the RH side and LH side.

  1. Remove the rear console armrest assembly.



3. REMOVE CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY


    B277995
  1. Remove the 2 screws.



    B277996
  1. Using a screwdriver, disengage the 8 claws.

    HINT:
    Tape the screwdriver tip before use.



    B277997
  1. Disengage the 2 guides to remove the console compartment door lock sub-assembly as shown in the illustration.



4. REMOVE CONSOLE COMPARTMENT DOOR CUSHION


    B277999
  1. Remove the 4 console compartment door cushions from the console compartment door lock sub-assembly.