Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0126    Lost Communication with Steering Angle Sensor Module

DTC    U0129    Lost Communication with Brake System Control Module

DTC    U0142    Lost Communication with Body Control Module "B"

for Preparation Click here


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:
If CAN communication system DTCs are stored, they may also be stored for other systems.


DTC No.
DTC Detection Condition
Trouble Area
U0100
Lost communication with ECM
CAN communication system
U0126
Lost communication with steering sensor
U0129
Lost communication with skid control ECU (brake actuator assembly)
U0142
Lost communication with main body ECU (multiplex network body ECU)

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTCs are output.
    A
    No DTCs are output.
    B

HINT:
  1. If CAN communication system DTCs are stored, they may also be stored for other systems.
  2. If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
  3. If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click here).



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)