Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)

AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA
  1. Whenever a DTC is detected, the AFS ECU (headlight swivel ECU assembly) stores the current vehicle (sensor) state as freeze frame data.


CHECK FREEZE FRAME DATA
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / AFS / DTC.

  5. According to the display on the intelligent tester, select the trouble code data display with freeze frame data.

    AFS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    AFS OFF Switch
    AFS OFF switch signal/ON or OFF
    ON: AFS off
    OFF: AFS on
    -
    Traveling Direction
    Traveling Direction/Not Fwd or Fwd
    Not Fwd: Shift lever in R or N
    Fwd: Shift lever not in R or N
    -
    Headlight Low Beam State
    Low beam headlight state/ON or OFF
    ON: Low beam headlights on
    OFF: Low beam headlights off
    -
    Headlight High Beam State
    High beam headlight state/ON or OFF
    ON: High beam headlights on
    OFF: High beam headlights off
    -
    Engine
    Engine condition/Run or Stop
    Run: Engine running
    Stop: Engine stopped
    -
    Steering Sens Signal
    Steering angle sensor signal value/-384.0 deg to 382.5 deg
    Condition can be displayed
    -
    FR Wheel Speed
    Front right wheel speed/0.00 to 327.67 km/h (203.61 mph)
    Condition can be displayed
    -
    FL Wheel Speed
    Front left wheel speed/0.00 to 327.67 km/h (203.61 mph)
    Condition can be displayed
    -
    Vehicle Acceleration
    Vehicle acceleration/-455.64 to 445.60 m/s2
    Condition can be displayed
    -
    Swivel Motor Slave
    Status of the swivel motor slave/Normal or Abnormal
    Condition can be displayed
    -
    Swivel Motor Over-Run
    Status of the swivel motor over-run/Normal or Abnormal
    Condition can be displayed
    -
    Leveling Motor Slave
    Status of the leveling motor Slave/Normal or Abnormal
    Condition can be displayed
    -
    Leveling Motor Over-Run
    Status of the leveling motor over-run/Normal or Abnormal
    Condition can be displayed
    -
    +B
    IG power supply voltage value/0.00 to 19.75 V
    11 to 14 V
    -


CLEAR FREEZE FRAME DATA

NOTICE:
Clearing the DTCs will also clear the freeze frame data.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Clear the DTCs and freeze frame data (Click here).