NOISE FILTER (for TMMK Made) > INSTALLATION |
| 1. INSTALL RADIO SETTING CONDENSER (for Window Defogger) |
![]() |
Engage the claw to install a new terminal cover to the wire harness.
![]() |
Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.
Engage the 2 clamps to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
| 2. INSTALL ROOF SIDE INNER GARNISH LH (for Window Defogger) |
Install 5 new clips to the roof side inner garnish LH.
Engage the guide.
Engage the 5 clips to install the roof side inner garnish LH.
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Window Defogger) |
![]() |
Align the alignment mark (Pink) on the weatherstrip with the protruding portion on the vehicle body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *a | Alignment Mark (Pink) |
| 4. INSTALL RADIO SETTING CONDENSER (for High Mounted Stop Light) |
![]() |
Engage the claw to install a new terminal cover to the wire harness.
![]() |
Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.
![]() |
Engage the claw to insert the cover as shown in the illustration.
Engage the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
| 5. INSTALL REAR SIDE SEATBACK ASSEMBLY LH |
Engage the hook.
Install the rear side seatback assembly LH with the 2 bolts.
Connect the connector.
Connect the rear seat outer belt assembly to the rear seat shoulder belt guide.
| 6. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 7. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.
![]() |
Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.
Confirm that the rear seat cushion assembly is securely installed.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT SRS WARNING LIGHT |