WINDSHIELD DEICER SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT FRONT WIPER DEICER SWITCH |
Check wire harness and connector.
![]() |
Disconnect the front wiper deicer switch connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (ILL+) - 4 (ILL-) | Headlight dimmer switch off → tail or head | Below 1 V → 11 to 14 V |
| 6 (D) - 3 (E) | Engine switch on (IG) | 11 to 14 V |
| 8 (IG) - 3 (E) | Engine switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| 4 (ILL-) - Body ground | Always | Below 1 Ω |
| 3 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Front Wiper Deicer Switch) |
Check that the front wiper deicer switch operates.
![]() |
Reconnect the front wiper deicer switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (D) - 3 (E) | Engine switch on (IG), front wiper deicer switch off → on | 11 to 14 V → Below 1 V (after 12 to 18 minutes: 11 to 14 V) |
| 8 (IG) - 3 (E) | Engine switch on (IG) | 11 to 14 V |
| *a | Component with harness connected (Front Wiper Deicer Switch) |
![]() |
Check that the indicator light illuminates.
| *a | Indicator Light |
| *b | Illumination |
Turn the engine switch on (IG).
Make sure that the indicator light illuminates when the front wiper deicer switch is turned on, and then goes off after 12 to 18 minutes elapse.
Check that the illumination illuminates.
Make sure that the illumination illuminates when the headlight dimmer switch is turned from off to tail or head.