Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER (for TMC, TMMR Made)

NOISE FILTER (for TMC, TMMR Made) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT RADIO SETTING CONDENSER (for High Mounted Stop Light)
  1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

  1. Remove the bolt.

  1. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.



    E211797E01
  1. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

    NOTICE:
    Before measuring the resistance and voltage, be sure to use insulated probes to avoid a short circuit between the tester terminal and bracket.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    1. Ignition switch off
    2. High mounted stop light off
    3. Window defogger off
    4. Luggage compartment room light off
    10 kΩ or higher
    1 - 3
    10 kΩ or higher
    1 - Body ground
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 - Body ground
    1. Ignition switch ON
    2. High mounted stop light off
    3. Window defogger off
    4. Luggage compartment room light off
    Below 1 V
    3 - Body ground
    Below 1 V
    2 - Body ground
    1. Ignition switch ON
    2. High mounted stop light on
    3. Window defogger on
    4. Luggage compartment room light on
    11 to 14 V
    3 - Body ground
    11 to 14 V

    Text in Illustration 
    *a
    Radio Setting Condenser



2. INSPECT RADIO SETTING CONDENSER (for Window Defogger)
  1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

  1. Remove the bolt.

  1. Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.



    E230106E01
  1. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (+B) - 2 (GND)
    1. Ignition switch off
    2. High mounted stop light off
    3. Window defogger off
    4. Luggage compartment room light off
    10 kΩ or higher
    3 - Body ground
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    1. Ignition switch ON
    2. High mounted stop light off
    3. Window defogger off
    4. Luggage compartment room light off
    Below 1 V
    1 - Body ground
    1. Ignition switch ON
    2. High mounted stop light on
    3. Window defogger on
    4. Luggage compartment room light on
    11 to 14 V

    Text in Illustration 
    *a
    Radio Setting Condenser