Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING (for TMC, TMMR Made)

ROOF HEADLINING (for TMC, TMMR Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE VANITY LIGHT ASSEMBLY
  1. Remove the vanity light assembly .

    HINT:
    Use the same procedure for the other vanity light.



2. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the 3 No. 1 roof silencer pads.


    B281364



3. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the No. 2 roof silencer pad.


    B281366



4. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.



  1. Remove the No. 2 antenna cord sub-assembly from the roof headlining.


    E302652E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *C
    w/ Television Antenna
    -
    -
    V100136
    Front
    V100155
    Tape



5. REMOVE NO. 1 ROOF WIRE


  1. Remove the adhesive tape from the roof headlining assembly.


    B281368E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *C
    w/o Rain Sensor
    *D
    for LHD with Rain Sensor
    *E
    for RHD with Rain Sensor
    -
    -
    *1
    Adhesive Tape
    -
    -

  1. Turn the visor connectors counterclockwise approximately 45° and separate the connectors from the roof headlining assembly.



  1. Remove the No. 1 roof wire from the roof headlining assembly.


    B281371E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof