Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING (for TMMK Made)

ROOF HEADLINING (for TMMK Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE VANITY LIGHT ASSEMBLY (w/ Sliding Roof)
  1. Remove the vanity light assembly .

    HINT:
    Use the same procedure for the other vanity light.



2. REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the 3 No. 4 roof silencer pads.


    B387540



3. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.



  1. Remove the No. 2 antenna cord sub-assembly from the roof headlining.


    E227852E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *1
    Tape
    -
    -
    *a
    Front
    -
    -



4. REMOVE NO. 1 ROOF WIRE


  1. Remove the adhesive tape from the roof headlining assembly.


    B396422E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *C
    w/ EC Mirror
    -
    -
    V100155
    Adhesive Tape
    -
    -

  1. w/ Sliding Roof:

    1. Turn the visor connectors counterclockwise approximately 45° and separate the connectors from the roof headlining assembly.



  1. Remove the No. 1 roof wire from the roof headlining assembly.


    B379605E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof



5. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the No. 2 roof silencer pad.


    B387548



6. REMOVE ROOF SIDE RAIL SILENCER PAD LH


  1. Remove the roof side rail silencer pad LH.


    B379541



7. REMOVE ROOF SIDE RAIL SILENCER PAD RH

HINT:
Use the same procedure as for the LH side.