CANISTER (for TMC, TMMR Made) > ON-VEHICLE INSPECTION |
| 1. INSPECT CHARCOAL CANISTER ASSEMBLY |
Visually check the charcoal canister.
Visually check the charcoal canister for cracks or damage.
Check charcoal canister operation under positive pressure.
![]() |
Disconnect the vent line hose from the charcoal canister assembly. Close the vent line hose using a hose plug or a similar part.
| *1 | Vent Line Hose |
| *2 | Test Hose |
| *a | Air |
Connect a test hose to the charcoal canister assembly.
Blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into the hose.
Check charcoal canister operation under vacuum.
Disconnect the vent line hose from the charcoal canister assembly. Close the vent line hose using a hose plug or a similar part.
Connect a test hose to the charcoal canister assembly.
Connect a vacuum pump to the test hose.
![]() |
Using the vacuum pump, apply vacuum and check the indicator.
| *1 | Vent Line Hose |
| *2 | Test Hose |
Check for clogs in the air filter (when not using the intelligent tester).
Disconnect the vent line hose from the charcoal canister assembly. Close the vent line hose using a hose plug or a similar part.
Connect a test hose to the charcoal canister assembly.
Connect a vacuum pump to the test hose.
Start the engine.
Warm up the engine.
After warm-up, idle the engine for 15 minutes and check the vacuum pump indicator.
Check for clogs in the air filter (when using the intelligent tester).
Disconnect the vent line hose from the charcoal canister assembly. Close the vent line hose using a hose plug or a similar part.
Connect a test hose to the charcoal canister assembly.
Connect a vacuum pump to the test hose.
Connect the intelligent tester to the DLC3.
Start the engine.
Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Evap Control.
Perform the Active Test with the engine idling.