CANISTER > ON-VEHICLE INSPECTION |
| 1. INSPECT CANISTER (CHARCOAL CANISTER ASSEMBLY) |
Visually check the canister (charcoal canister assembly).
Visually check the canister (charcoal canister assembly) for cracks or damage.
If cracks or damage are found, replace the canister (charcoal canister assembly).
Check canister (charcoal canister assembly) operation under positive pressure.
![]() |
Slide the clip and disconnect the vent line hose from the canister (charcoal canister assembly).
| *1 | Vent Line Hose |
| *a | Test Hose |
| *b | Air |
Close the vent line hose using a hose plug or similar part.
Connect a test hose to the canister (charcoal canister assembly).
Blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into the test hose and check that air passes through the canister (charcoal canister assembly).
If the result is not as specified, replace the canister (charcoal canister assembly).
Check canister (charcoal canister assembly) operation under vacuum.
![]() |
Slide the clip and disconnect the vent line hose from the canister (charcoal canister assembly).
| *1 | Vent Line Hose |
| *a | Test Hose |
| *b | Vacuum Pump |
Close the vent line hose using a hose plug or similar part.
Connect a test hose to the canister (charcoal canister assembly).
Connect a vacuum pump to the test hose.
Using the vacuum pump, apply vacuum and check that the vacuum pump indicator does not move from its initial position.
Check for clogs in the air filter (when not using the GTS).
![]() |
Slide the clip and disconnect the vent line hose from the canister (charcoal canister assembly).
| *1 | Vent Line Hose |
| *a | Test Hose |
| *b | Vacuum Pump |
Close the vent line hose using a hose plug or similar part.
Connect a test hose to the canister (charcoal canister assembly).
Connect a vacuum pump to the test hose.
Start the engine.
Warm up the engine.
Idle the engine for 15 minutes and check that the vacuum pump indicator does not move from its initial position.
Check for clogs in the air filter (when using the GTS).
![]() |
Slide the clip and disconnect the vent line hose from the canister (charcoal canister assembly).
| *1 | Vent Line Hose |
| *a | Test Hose |
| *b | Vacuum Pump |
Close the vent line hose using a hose plug or similar part.
Connect a test hose to the canister (charcoal canister assembly).
Connect a vacuum pump to the test hose.
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Activate the EVAP Purge VSV.
Check that the vacuum pump indicator does not move from its initial position.