Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR (for TMMK Made)

OUTER REAR VIEW MIRROR (for TMMK Made) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE OUTER MIRROR


    B381037E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.

  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.



    B381038E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the lower part of the mirror surface and tilt it.

  1. Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.

  1. Remove the outer mirror.



2. REMOVE OUTER MIRROR COVER


    B381042
  1. Remove the 3 screws.



    B381043
  1. Disengage the clamp.

  1. Disconnect the connector and remove the mirror actuator.



    B381044
  1. Disengage the 7 claws and remove the outer mirror cover.



3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    E225012
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the side turn signal light assembly.