Home › Vehicle Interior › SEAT › POWER SEAT SWITCH (for TMMK Made)

POWER SEAT SWITCH (for TMMK Made) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


    B269607
  1. Using a moulding remover, disengage the 4 claws to remove the slide and vertical power seat switch knob.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB


    B269611
  1. Using a moulding remover, disengage the 4 claws to remove the reclining power seat switch knob.



4. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER


    B280155
  1. Disconnect the 2 rubber bands of the separate type front seatback cover.



5. REMOVE FRONT SEAT CUSHION SHIELD


    B280159
  1. Remove the screw.

  1. Disengage the 2 claws to remove the front seat cushion shield.



    B280160
  1. Disengage the wire harness clamp.

  1. Disconnect the front power seat switch connector.



  1. for Driver Side:



      B280167
    1. Disengage 4 claws to remove the front lumbar power seat switch from the front seat cushion shield.



6. REMOVE FRONT POWER SEAT SWITCH


    B280168
  1. Remove the 3 screws and front power seat switch from the front seat cushion shield.