Home › Vehicle Interior › SEAT › POWER SEAT SWITCH (for TMMR Made Front Side with Seat Position Memory System)

POWER SEAT SWITCH (for TMMR Made Front Side with Seat Position Memory System) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE FRONT SEAT ASSEMBLY LH
(Click here)


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


    B269607
  1. Using a moulding remover, disengage the 4 claws to remove the slide and vertical power seat switch knob.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB


    B269611
  1. Using a moulding remover, disengage the 4 claws to remove the reclining power seat switch knob.



4. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER


    B281093
  1. Disconnect the rubber band of the separate type front seatback cover.



5. REMOVE FRONT NO. 1 SEAT INNER CUSHION SHIELD LH


    B281094
  1. Remove the screw.

  1. Disengage the 2 claws to remove the front No. 1 seat inner cushion shield LH from the clip as shown in the illustration.



    B281097
  1. Disengage the 3 claws and 3 guides to remove the front No. 1 seat inner cushion shield LH as shown in the illustration.



6. REMOVE FRONT SEAT CUSHION SHIELD LH


    B281098
  1. Disengage the 4 claws, 7 guides and clip to remove the front seat cushion shield LH.



    B269629E02
  1. Disengage the 2 claws and open the wire harness cover.
    Text in Illustration 
    *1
    Wire Harness Cover

  1. Remove the wire harness from the wire harness cover.

  1. Disengage the 2 wire harness clamps.

  1. Disconnect the 2 connectors from the position control ECU and switch assembly.



    B288620
  1. Disconnect the connector from the front lumbar power seat switch.



7. REMOVE POSITION CONTROL ECU AND SWITCH ASSEMBLY


    B269631
  1. Remove the 3 screws and position control ECU and switch assembly from the front seat cushion shield LH.