LUMBAR SWITCH (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL FRONT LUMBAR POWER SEAT SWITCH |
Engage the 4 claws to install the front lumbar power seat switch to the front seat cushion shield.
| 2. INSTALL POSITION CONTROL ECU AND SWITCH ASSEMBLY (w/ Seat Position Memory System) |
Install the position control ECU and switch assembly to the front seat cushion shield LH with the 3 screws.
| 3. INSTALL FRONT SEAT CUSHION SHIELD |
Connect the front lumbar power seat switch connector.
Connect the front power seat switch connector.
Engage the 2 wire harness clamps.
Install the wire harness to the wire harness cover.
Engage the 2 claws to close the wire harness cover.
Engage the 4 claws, 7 guides and clip to install the front seat cushion shield.
| 4. INSTALL FRONT NO. 1 SEAT INNER CUSHION SHIELD |
![]() |
Engage the 3 claws and 3 guides to install the front No. 1 seat inner cushion shield as shown in the illustration.
![]() |
Engage the 2 claws to install the front No. 1 seat inner cushion shield to the clip as shown in the illustration.
Install the screw.
| 5. CONNECT SEPARATE TYPE FRONT SEATBACK COVER |
Connect the rubber band of the separate type front seatback cover.
| 6. INSTALL RECLINING POWER SEAT SWITCH KNOB (w/ Seat Position Memory System) |
Engage the 4 claws to install the reclining power seat switch knob.
| 7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (w/ Seat Position Memory System) |
Engage the 4 claws to install the slide and vertical power seat switch knob.
| 8. INSTALL FRONT SEAT ASSEMBLY |