Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH

VACUUM WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CHECK VALVE GROMMET
  1. Install a new check valve grommet to the brake booster assembly.



2. INSTALL VACUUM WARNING SWITCH ASSEMBLY


    C323337E01
  1. Install the vacuum warning switch assembly to the brake booster assembly as shown in the illustration.
    Text in Illustration 
    *a
    30° +/- 10°
    V100136
    Up

  1. Connect the engine wire connector to the vacuum warning switch assembly.



3. INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY
  1. Install the front outer cowl top panel sub-assembly with the 10 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the 2 clamps to install the wire harness to the front outer cowl top panel sub-assembly.

  1. w/ Windshield Deicer System:

    1. Connect the connector.

    2. Engage the 2 clamps to install the wire harness to the front outer cowl top panel sub-assembly.

  1. w/ Heated Windshield Defroster System:

    1. Connect the 2 connectors.

    2. Engage the 4 clamps to install the wire harness to the front outer cowl top panel sub-assembly.



4. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY