Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP

VACUUM PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT UNION TO CHECK VALVE HOSE


    C314605
  1. Slide the clip and disconnect the union to check valve hose from the vacuum pump assembly.



2. OPERATION CHECK


    C318405E01
  1. Connect the hose of a vacuum gauge to the vacuum pump assembly.
    Text in Illustration 
    *a
    Vacuum Gauge

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, measure the negative pressure of the vacuum pump assembly.

    Standard pressure:
    Higher than 86.7 kPa (650 mmHg, 25.6 in.Hg)

    HINT:
    If the result is not as specified, replace the vacuum pump assembly.

  1. Remove the vacuum gauge from the vacuum pump assembly.



3. CONNECT UNION TO CHECK VALVE HOSE
  1. Connect the union to check valve hose to the vacuum pump assembly, and slide the clip to secure it.