Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR GLASS (for TMC, TMMR Made)

OUTER REAR VIEW MIRROR GLASS (for TMC, TMMR Made) > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR RH
  1. Check the shape of the heater wire.



  1. Check the outer mirror heater operation.


    B360114E01


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Heater Wire Shape A 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω
      Heater Wire Shape B 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      9.2 to 13.8 Ω


      Text in Illustration 
      *A
      Heater Wire Shape A
      *B
      Heater Wire Shape B
      *a
      Component without harness connected
      (Outer Mirror RH)
      *b
      Heater Wire
      If the result is not as specified, replace the outer mirror RH.



  1. Check the operation of the outer rear view mirror indicator (w/ Blind Spot Monitor System).

    NOTICE:
    Do not apply a voltage of more than 6 V.


    1. Connect 4 new 1.5 V dry-cell batteries in series.



    2. E299433E01
    3. Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

      OK:
      Tester Connection
      Specified Condition
      6 V battery positive (+) → Terminal 2
      6 V battery negative (-) → Terminal 1
      Outer rear view mirror indicator comes on

      Text in Illustration 
      *a
      Component without harness connected
      (Outer Mirror RH)
      If the result is not as specified, replace the outer mirror RH.



2. INSPECT OUTER MIRROR LH
  1. Check the shape of the heater wire.



  1. Check the outer mirror heater operation.


    B360115E01


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Heater Wire Shape A 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω
      Heater Wire Shape B 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      9.2 to 13.8 Ω


      Text in Illustration 
      *A
      Heater Wire Shape A
      *B
      Heater Wire Shape B
      *a
      Component without harness connected
      (Outer Mirror LH)
      *b
      Heater Wire
      If the result is not as specified, replace the outer mirror LH.



  1. Check the operation of the outer rear view mirror indicator (w/ Blind Spot Monitor System).

    NOTICE:
    Do not apply a voltage of more than 6 V.


    1. Connect 4 new 1.5 V dry-cell batteries in series.



    2. E299432E01
    3. Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

      OK:
      Tester Connection
      Specified Condition
      6 V battery positive (+) → Terminal 2
      6 V battery negative (-) → Terminal 1
      Outer rear view mirror indicator comes on

      Text in Illustration 
      *a
      Component without harness connected
      (Outer Mirror LH)
      If the result is not as specified, replace the outer mirror LH.