FRONT SEAT SIDE AIRBAG ASSEMBLY (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL FRONT SEAT AIRBAG ASSEMBLY |
Install the front seat airbag assembly with 2 new nuts.
Engage the 2 clamps.
| 2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat) |
Temporarily install the separate type front seatback cover with pad.
Engage the 4 claws to install the 2 front seat headrest supports.
Install the 2 brackets with the nut.
![]() |
Turn back the separate type front seatback cover.
Using hog ring pliers, install 2 new hog rings.
![]() |
Using hog ring pliers, install 3 new hog rings.
![]() |
Using hog ring pliers, install 5 new hog rings.
| 3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat) |
Temporarily install the separate type front seatback cover with pad.
Engage the 4 claws to install the 2 front seat headrest supports.
Install the 2 brackets with the nut.
![]() |
Turn back the separate type front seatback cover.
Using hog ring pliers, install 2 new hog rings.
![]() |
Using hog ring pliers, install 3 new hog rings.
![]() |
Using hog ring pliers, install 5 new hog rings.
| 4. CONNECT AIRBAG WIRE HARNESS (for Manual Seat) |
w/ Seat Heater System:
Engage the clamp.
Connect the connector.
Engage the claw and 3 clamps to connect the airbag wire harness.
Engage the fastener to install the airbag wire harness.
Connect the rubber band of the separate type front seatback cover with pad.
| 5. CONNECT AIRBAG WIRE HARNESS (for Power Seat) |
w/ Seat Heater System:
Engage the clamp.
Connect the connector.
Engage the claw and 3 clamps to connect the airbag wire harness.
Engage the fastener to install the airbag wire harness.
Connect the rubber band of the separate type front seatback cover with pad.
| 6. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) |
| 7. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) |
| 8. PERFORM DIAGNOSTIC SYSTEM CHECK |