- Cylinder head sub-assembly
- Camshaft (for intake or exhaust camshaft)
- Camshaft timing gear assembly
- Camshaft timing exhaust gear assembly
- Piston or piston ring
- Mass air flow meter sub-assembly
- Fuel injector assembly (for port injection)
- Fuel injector assembly (for direct injection)
- Fuel pump (for low pressure side)
- Fuel pump (for high pressure side)
- Air fuel ratio sensor
- Engine coolant temperature sensor
- Spark plug
- Ignition coil assembly
- EGR valve assembly
- Air leaks from intake system
- Gas leaks from exhaust system
| Confirm the following: Perform learning value reset and idle learning when one or more of the following conditions is met.
- A DTC was output before component replacement.
- An air fuel ratio learned value (one of A/F Learn Value Idle Bank 1, A/F Learn Value Low Bank 1, A/F Learn Value Mid No.1 Bank 1, A/F Learn Value Mid No.2 Bank 1, A/F Learn Value High Bank 1, A/F Learn Value Low (Dual) Bank 1, A/F Learn Value Mid (Dual) No.1 Bank 1, A/F Learn Value Mid (Dual) No.2 Bank 1 or A/F Learn Value High (Dual) Bank 1) displayed in the Data List was higher than +/- 20% before component replacement.
- Starting failure, rough idle, or engine stalls after component replacement.
| ○
| ○
|