Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE METER / GAUGE SYSTEM
  1. Customizing with the GTS

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Customize Setting / Warning.

    5. Select the setting by referring to the table below.

      NOTICE:
      1. Record the current settings before customizing.


      Warning 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      Key Remind Sound
      Slow
      Function to change the frequency of the key reminder warning buzzer
      Fast, Normal, Slow
      Combination meter assembly
      Flasher Sound Volume Adjustment*1
      Medium
      Function to change to flasher sound volume
      Large, Medium, Small
      Combination meter assembly
      Lane Change Flashing Times Setting
      3
      Function to change the lane change flashing time
      OFF, 3, 4, 5, 6, 7
      Combination meter assembly

      Display 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      ODO Display Time After IG OFF Setting*2
      30s
      Function to change the odometer display time after the ignition switch is turned off
      OFF, 30s, 60s, 600s
      Combination meter assembly
      1. *1: except TMMK Made
      2. *2: for TMMK Made