LIGHTING SYSTEM > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE LIGHTING SYSTEM (EXT) |
Customizing with the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Utility / Customize / Light Control.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Disp Ex ON Sen | Normal | Changes the ambient brightness level required to dim the lights such as the indicator lights of the combination meter, A/C indicator light and clock.*A | Light2, Light1, Normal, Dark1 or Dark2 | Main Body ECU (Multiplex Network Body ECU) |
| Disp Ex OFF Sen | Normal | Changes the ambient brightness level required to cancel the dimming of the lights such as the indicator lights of the combination meter, A/C indicator light and clock.*B | Light2, Light1, Normal, Dark1 or Dark2 | |
| Response Time | Normal | Changes the delay timing of lighting the taillights when going into a tunnel when the light control switch is in the AUTO position | Normal or Long | |
| Sensitivity | Normal | Adjusts the sensitivity of the automatic light control system.*C | Light2, Light1, Normal, Dark1 or Dark2 | |
| DRL Function* | ON | ON/OFF of the DRL function | ON or OFF |
| Brightness level required to dim the lights | ![]() | ||||
| Setting | Dark2 | Dark1 | Normal | Light1 | Light2 |
| Brightness level required to cancel the dimming of the lights | ![]() | ||||
| Setting | Dark2 | Dark1 | Normal | Light1 | Light2 |
| Sensitivity of the automatic light control system | ![]() | ||||
| Setting | Dark2 | Dark1 | Normal | Light1 | Light2 |
Customizing with multi-display
Turn the ignition switch to ON.
Enter the following menus: MENU or APPS / Vehicle / Vehicle customization / Lights settings. (w/ Audio and Visual System)
Enter the following menus: SETUP / Vehicle / Vehicle customization / Lights settings. (w/ Navigation System (for Radio and Display Type)
Enter the following menus: MENU / Vehicle / Vehicle customization / Lights settings. (w/ Navigation System (for Navigation Receiver Type)
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Light sensor sensitivity | 0 | Adjusts the sensitivity of the automatic light control system.*A | -2, -1, 0, +1 or +2 | Main Body ECU (Multiplex Network Body ECU) |
| Daytime running lights* | On | ON/OFF of the DRL function | On or Off |
| Sensitivity of the automatic light control system | ![]() | ||||
| Setting | -2 | -1 | 0 | +1 | +2 |