PUSH-BUTTON START > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE PUSH-BUTTON START |
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Entry & Start / Utility / Customize / Entry & Start or Warning
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Ignition Available Area (Entry ignition available area) | All | Function that sets the area that the key must be in before the engine switch can be operated. | Front or All | Certification ECU (smart key ECU assembly) |
| Auto Entry Cancel SW | OFF | Function that enables or disables the smart entry and start system. | OFF or ON | Certification ECU (smart key ECU assembly) |
| Engine Start Indicator | ON | Function that turns the smart warning light on the combination meter assembly on or off. | OFF or ON | Certification ECU (smart key ECU assembly) |
| Display | Default | Content | Setting | Relevant ECU |
| Key Low Battery Warning (Warn when key battery becomes weak) | ON | Enables or disables the sounding of the buzzer when the transmitter battery is low and the engine switch is turned off after being on (IG) for 20 minutes or more. | ON or OFF | Certification ECU (smart key ECU assembly) |
Customizing with the multi-display (w/ Audio and Visual System)
Turn the engine switch on (IG).
Enter the following menus: MENU or APPS / Vehicle / Vehicle customization / Door lock settings.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Entry and start system | On | Function that enables or disables the smart entry and start system. | On or Off | Certification ECU (smart key ECU assembly) |
Entry cancel function (manual operation)
The following functions are disabled when the push-button start is canceled.
When canceling the system through manual operation:
Perform the following procedure to restore the push-button start to the active state from the canceled state.