Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR COVER (for TMC, TMMR Made)

OUTER REAR VIEW MIRROR COVER (for TMC, TMMR Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE OUTER MIRROR (w/o Memory)


    B280618E04
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.



    B280619E03
  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.
    Text in Illustration 
    *a
    Moulding Remover



    B280621
  1. Disengage the 2 guides as shown in the illustration.



    B280623
  1. Disconnect the 2 connectors and remove the outer mirror.



2. REMOVE OUTER MIRROR (w/ Memory)


    B384676E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.

  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.



    B384677E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape

  1. Push the lower part of the mirror surface and tilt it.

  1. Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.



    B384681E01
  1. Disconnect the mirror heater connector.
    *a
    Mirror Heater Connector
    *b
    Blind Spot Monitor Indicator Connector

  1. Disengage the 2 claws.

  1. Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

    NOTICE:
    1. Do not bend the tabs excessively to prevent them from being damaged.
    2. If the tabs are damaged, replace the outer mirror with a new one.



3. REMOVE OUTER MIRROR COVER (w/o Memory)


    B280624
  1. Remove the 3 screws.



    B280625
  1. Disengage the clamp.

  1. Disconnect the 2 connectors and remove the mirror actuator.



    B280627
  1. Disengage the 7 claws and remove the outer mirror cover.



4. REMOVE OUTER MIRROR COVER (w/ Memory)


    B386127
  1. Disengage the 5 claws.



    B386129E01
  1. Disengage the 2 claws to remove the outer mirror cover as shown in the illustration.

    HINT:
    When removing the outer mirror cover, pull the outer mirror cover horizontally along the lower part of the outer rear view mirror assembly.